7 Easy Steps Through Which Professionals Install Front Doors In Horsham

Though installing a front door looks quite simple, it is actually not so. Numerous steps are involved and trying a DIY is a strict no-no! Adopting a straightforward approach is a must if you want the installation to be completed within the shortest span of time and with minimum hassles. Professional installers follow few vital steps while installing a pre-hung door so that the functionality of the product is high and homeowners can make the most out of it.

Steps Adopted By Professionals Installing Front Doors In Horsham

• Measurement Taken
  Since you already have an opening, professionals measure the height, depth, and weight of the existing door before crafting the new product. The condition of the door is assessed and width of the jam measured. Extra care is taken to keep the measurements accurate, especially if they are measuring rough openings.


• Existing Door Removed
  While removing the existing product, they start by pulling off both the interior and exterior trims. Though exterior trims are attached with a majority of the modern door frames, it is always better to keep them all in one piece. The end of the pry bar is eased before pulling it free. Finally, the door is detached from the jam after removing the hinge pins. Installers detach and remove the sill, jamb, and shims as well.


• Fix Waterproofing
  The waterproofing in the wall might get affected while the door is being removed especially if the overhang is small and your door is left exposed. Professionals examine and check the opening for any water damage and if required, fix the waterproofing and replace the flash.


• Sill Set
  The sill is then prepared to establish the ideal height by using treated lumber. The lumber is either screwed or glued with the deck according to the requirement of the project. A two-foot-level is used to test whether the sill plate is level or not.


• Frame Installation
  Professionals can set the door frame with ease by following the manufacturer’s instructions. A bead of caulk is applied in the opening before installing the frame. To ensure that the new frame is square and plumb, a four-foot level is used. After installing your Front Doors in Horsham, check whether they are operating properly.


• Insulate
  Expanding foam is then put between the framing material and the jamb. This helps in insulating and caulking the frame. A minimum amount of expanding foam is used and it should never be treated as a substitute of proper waterproofing. Large fiberglass insulation is used if the gaps are large.


• Casing And Hardware
  After the door has been installed, casing and hardware are added. The interior opening is finished by applying interior casing. Finally, hardware like handles, deadbolts, and locks are installed. You can even consult with your installer and ask whether they can provide the hardware.

Since your front door is the face of your property in Horsham, approaching experienced professionals to install the product is always a better option!